|  |  Wheel Spacers
These wheel spacer kits from H&R include everything you need to push your wheels our farther from the hub, safely and with the security that it's being done the right way. All spacers are hubcentric to the car as well as the wheel, so there's no slop or play.
Spacing the wheels out farther can allow the fitment of larger brakes. Plus, the wider stance gives a lower roll center and increased lateral stability.
H&R wheel spacers are made in Germany, TUV approved. Lightweight magnesium/aluminum alloy is as much as 70% lighter than an equivalent steel part.
Mach V wheel spacers are made here in the U.S.A. from super-strong T6061 aluminum. We made them extra-snug to prevent any slop or wobbling, and they are DUAL DRILLED so they'll fit both 5x100 and 5x114 Subaru models!
Of course, moving the wheels outward too far can result in tire-to-fender clearance problems. Use these kits at your own risk; we will not accept returns based on fitment.
Each kit comes with two spacers and extended studs -- enough for one end of the car. (If you want spacers for the whole car, order two kits.) The 25mm kits incorporate their own studs and special low-profile lug nuts.
For all 5x100 bolt pattern Subaru cars. The 10mm Mach V kit also fits all 5x114 bolt pattern Subarus.
Installation tip: Use a 12mm x 1.25 standard nut (not a lug nut) along with a couple of large flat washers braced against the brake rotor to pull the stud into the back side of the hub.
NOTE: The Mach V 10mm spacer kit is very tight in terms of clearance from the inside of the car hub to the inside of the spacer -- this is necessary because of the geometry of making a 10mm spacer. You MUST test-fit the spacer on the car to make sure there is clearance. Rotor hats do vary in thickness; if you have an extra-thin rotor hat, the hub may poke out higher than the depth of the wheel spacer. In that case, you will need to remove some material from the hub in order for the spacer to sit down flat on the rotor hat. We will not accept returns if the spacer is damaged by a protruding hub.
|
|  H&R Wheel Spacer Kit - 5mm5x100 only.
| | |  Mach V 10mm Spacer Kit With ARP Wheel StudsFits 5x100 or 5x114 Subarus.
| | |  Mach V 10mm Wheel Spacers - no studsGet these if you already have extended wheel studs. Set of two spacers.
| | |  H&R Wheel Spacer Kit 15mm5x100 only.
| | |  H&R Wheel Spacer Kit 25mm5x100 only.
| |
|
|
| |
