|  |  WRX and STi Marque Plates
Available in stainless steel or matte black. The WRX plate is license-plate sized. The STi one is a little smaller -- see pic at left and below. Great for shows and meets, or use in place of a front license plate where state law allows. Both come with bolt covers.
NOTE! There are pre-molded holes on the front bumper of the WRX or STI, that are NOT used to hold on the license plate (at least in the U.S.). This trim part does NOT install into these holes! If your dealership attached a front license plate to the car, you'll be using those smaller screw holes. If not, you'll need to drill small holes for the included screws. There are small dimples in the bumper to indicate where these holes are to be drilled. Even if you can't find the dimples, you can always hold the plate up to the bumper... (See "Which holes to use" pic below.)
|
|  WRX Marque Plate
| | |  STi Marque Plate4" high x 12" wide
| | |  Which holes to use (2002-07)
| | |  Which holes to use (2008+)
| |
|
|
| |
