FA20T omnipower plasticmani VAWRX

, b_code, e_code, mani_type

Omni Power 4-Bar MAP Sensor 2015+ WRX

FA20T omnipower plasticmani VAWRX

, b_code, e_code, mani_type

  • NOTE: READ the WHOLE product description before purchasing this sensor. This is NOT a drop-in replacement for the stock MAP sensor.

    The stock Subaru MAP sensor (it's actually a temperature AND manifold absolute pressure sensor, or TMAP) maxes out at 27 or so psi. If you want to control boost at higher pressures, you'll need a sensor that can cope.

    Omni Power MAP (Manifold Absolute Pressure) sensors use state of the art bipolar op amp circuitry with thin film resistor networks built into each micro chip.

    Pressure changes are calculated on a true linear 0-5 volt scale via a specially designed silicon pressure sensor that also compensates for temperature changes. The unique ability to compensate for temperature changes allows the Omni Power 4-bar MAP sensor to remain a minimum of 99% accurate from 32 degrees F to 180 degrees F through out its range of scale.

    With the true linear pressure vs. voltage scale there is never a need to re-tune at different altitudes as with other sensors. Competitors' sensors on the market don't have true linear scaling which can cause your engine to go out of tune with elevation changes, often resulting in idle problems, poor drivability, and catastrophic engine damage.

    Omni Power 4-bar MAP sensors can precisely calculate boost pressure from 1-43+ psi while still allowing smooth stock OEM drivability at any boost level. Conveniently packaged in an OEM dimensional housing for easy install and an OEM look.

    Bolts directly in place of the stock intake temp/MAP sensor. This sensor REQUIRES custom ECU tuning. It will not work with the stock ECU tune or off-the-shelf tuning maps.

    Fits all 2015+ Subaru WRX.

  • SKU#: 08437VA

    Shipping Weight: 1.0 lb

    Supplier: Omni Power

    Category: Other Accessories, Sensors & Electronics