Turn In Concepts Trailing Arm Rear Bushing Kit 2002-2007 WRX/STI

This kit replaces the stock bushings in the REAR part of the trailing arm of GD Impreza-chassis cars.

Bushings can make a big impact for a small out of pocket cost, and this one is no exception. It firms up the rear end, leads to more precision during driving, reduces dynamic reflection, and removes an undamped spring from your suspension (the old one is a really bouncy rubber).

Like all of TIC's newest generation suspension bushings this one has the following features:

• Shore 95A medical grade urethane (this means no heavy metals are used in the manufacture)
• Graphite impregnation for self lubrication
• Split design for easy install
• Stainless steel crush tube milled from solid stock

Installation is simple:

• Unbolt trailing arm from rear knuckle and pull arm down out of the way.
• Remove stock bushing (heat works nicely for this, but watch where your flames go)
• Clean up left over bits of the stock bushing in the bore.
• Insert new bushing halves Insert crush tube (C-clamp works well for this)
• Align bolt hole
• Insert bolt
• Torque to 66 lbs

Some additional tips: We know they are self lubricating. Believe me, we know, we designed the things. Despite this it's not going to hurt anything to use a little bit of lube when you assemble, BUT please use a water based lube. Petroleum lube will decay urethane (and rubber too). Before you completely tighten the bolt put the car down so it's sitting an normal suspension load. This will eliminate any preload in the bushing. Coffee and a sandwich are always good snacks for when you do installs.

Fits all 2002-2007 Subaru WRX and STI.